EFD1000 E5 Dual Electronic Flight Instrument (EFI) Install Manual
DOCUMENT # 900-00041-001
PAGE 211-226
REVISION D
© Copyright 2019 Aspen Avionics Inc.
Figure E13: EA100 to KFC250 (without KA141) Attitude Source w/Disc
Figure E14: Reserved
1
2
2
A/P AHRS FAIL light must be installed in the pilots primary field of view. Use light/dimmer/
test switch P/N MS25041-4. Wire as shown.
43
44
3
A/P AHRS COMM
A/P AHRS INVALID
A/P AHRS FAIL
GENERAL INSTALLATION NOTES
All wires in this section 22AWG unless otherwise specified
All grounds should be as short as possible
Terminate all shields within connector back shell
H
AP POWER
KI 25X
A/P circuit
breaker
(existing)
existing wire
3
4
P2
2
1
3
MS25041-4
20 AWG
20 AWG
Use 20 AWG or wire size appropriate for A/P circuit breaker rating. Wire may be spliced
to a 22 AWG wire not more than 4 inches in length at the EA100 to accommodate the
high density pin size.
5
EA100
6
7
8
The existing autopilot disconnect circuit from the KA136 must be run through an internal
relay within the EA100. This ensures the autopilot cannot be engaged or will disengage if
the EA100 attitude is invalid. Wire as shown.
Only KCP299 flight computers with adapter board 065-5016-XX may
use this drawing. Flight computers with 065-5015-XX adapter boards
not approved.
18 AWG wire may be spliced to a 22 AWG wire of no more than 4
inches in length at the EA100 to accommodate the high density pin.
6
9
EA100
41
39
18
3
16
1
P2
AP EXCITE HI
AP EXCITE LO
AP ROLL HI
AP ROLL LO
A/P INTRLK COMM
A/P INTRLK ENERGIZED
17
2
AP PITCH HI
AP PITCH LO
F
y
s
10VAC 400HZ
PITCH ATT
P2991
ROLL ATT
PWR REF
P2992
After
w
CC
ATT REF
HH
with P/N 065-5016-XX
Adapter Board (for 3"
instruments)
KFC250 autopilots with a KA141 cannot use this drawing. See appropriate wiring diagram
in this manual.
KCP299 Flight
Computer
without KA141
ATT REF
1
8
A
W
G
1
8
A
W
G
9
8
5
Before
A/P DISC from KA136 to KCP299
A/P DISC IN
Existing Wire
P2991 P2992
KA136 Trim Adapter
A/P DISC
L
P1362
j
KCP299 Flight Computer
without KA141
with P/N 065-5016-XX Adapter
Board (for 3" instruments)
Existing Wire
Existing Wire
KA136 Trim Adapter
A/P DISC
L
P1362
A/P DISC IN
P2991 P2992
j
KCP299 Flight Computer
without KA141
with P/N 065-5016-XX Adapter
Board (for 3" instruments)
8
8
Remove existing wire from P2992 pin j and extend to EA100 pin 39. Run new
wire from P2992 pin j to EA100 pin 41.
7
1
1
KFC autopilots with flight director will retain the KI255/256 for FD display.
Note 4 not applicable to this drawing