EFD1000 E5 Dual Electronic Flight Instrument (EFI) Install Manual
DOCUMENT # 900-00041-001
PAGE 168-226
REVISION D
© Copyright 2019 Aspen Avionics Inc.
SYSTEM DESCRIPTION
POSITION
EFD1000 E5 System
Pass Fail
AIR DATA
Verify the EFD1000 E5 altimeter is presenting correct and steady
information while monitoring the effects of the peripheral Threat
Equipment.
AUTOPILOT (If Installed)
Verify the autopilot operates correctly while monitoring the effects of
the Threat Equipment. Sufficient testing should be accomplished to
provide confidence in system operation. If this level of testing is not
possible, the autopilot should not be engaged in flight until a safe
altitude has been achieved.
COMPASS SYSTEM
Verify the EFD1000 E5 compass system is presenting correct
information while monitoring the effects of the peripheral Threat
equipment.
ATTITUDE SYSTEM
Verify the EFD1000 E5 attitude system is presenting correct
information while monitoring the effects of the peripheral Threat
equipment.
SAFETY EQUPIMENT
WEATHER RADAR (If Installed)
Verify the function of the weather radar system while monitoring the
effects of the Threat equipment. Prior to ground operation of the
radar, proper safety precautions need to be observed to prevent injury
or damage to ground personnel or equipment.
RADIO ALTIMETER (If Installed)
Verify the radio altimeter system functions correctly while monitoring
the effects of the Threat equipment. The radio altimeter should self
test correctly and be free of continuous variation while parked on the
ramp.
ENGINE INDICATING AND FUEL QUANTITY
Start the aircraft engine(s) and configure the aircraft for normal in-
flight operations (i.e. pitot heat, lights, etc.) Verify the engine
instruments display correct and stable information while monitoring
the effects of the Threat Equipment. This may be accomplished
immediately prior to flight-testing if practicable.
ENGINE
FUEL
QTY
CONTROL SURFACE POSITION INDICATIONS
Verify operation of flaps and electric trim while monitoring the effects
of the threat equipment. Surfaces should move smoothly through the
entire range of operation without interference.
FLAPS
ELEC TRIM