ashtech Reliance FS/2, Operation Manual

Page: 164 / 186

C-6 Reliance with FS/2 Field Operations Manual
3. Tilt the unit to slide out the batteries.
4. Slide fresh batteries into the battery compartment, positive end first.
If you are fitting AA batteries, it is advisable to fit the packing sleeve supplied with the FS/2.
5. Refit the battery cap.
6. Seat it with finger pressure first, and make sure that the cap has engaged the
socket threads,
7. Tighten with a suitable coin.
8. Turn on and check operation. If the FS/2 does not turn on, contact Ashtech or
your dealer.
Whenever the batteries are replaced, set the status the condition of the new batteries.
CAUTION
After changing batteries, you MUST ensure that the battery type, capacity,
and power management are correctly set. (Refer to your FS/2 Quick
Reference Guide)
CAUTION
If you have changed from rechargeable to non-rechargeable batteries, warn
anyone who uses the unit. Non-rechargeable batteries must NOT be
recharged. Always use batteries of the same type and charge state—do not
mix fresh and used batteries, or rechargeable and non-rechargeable batteries.
Observe the instructions printed on the battery. Replace only with batteries
approved by your FS/2 supplier. DO NOT USE LITHIUM BATTERIES.
CAUTION
Dispose of or recycle used batteries according to the manufacturer’s
instructions. Nickel-cadmium rechargeable batteries must be recycled or
disposed of properly.
CAUTION
BATTERY CHEMICAL LEAKAGE IS CORROSIVE. In the unlikely event
of battery leakage, do not touch. In case of accidental contact, flush
immediately with copious amounts of water.