TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
44
Note:
In order to determine the IP address it is necessary that the computer is connected
to the same LAN (broadcast domain) as the IPBS/IPBL.
Determine the IP address following the steps below:
Note:
If the IPBS/IPBL has been used before, it must be restored to factory default settings
by performing a long hardware reset, see
8.23
Reset Using the Reset Button
on page 138.
Then remove the power supply cable and connect it again.
1
Open a command window in windows by selecting Start > Run and enter "cmd" in
the
Open:
text field.
2
Enter the following commands:
C:\ nbtstat -R
C:\ nbtstat -a ipbs-xx-xx-xx
(in case of IPBL, enter "ipbl-xx-xx-xx")
Where xx-xx-xx should be replaced with the last 6 hexadecimal digits of the MAC-
address.
3
The IP address is displayed in the command window, see the white frame in figure
below.
Figure 17.
4
Enter http://xxx.xxx.xxx.xxx (where
xxx.xxx.xxx.xxx
is the determined IP address) in
the browser to access the GUI.
5
After the first startup of the IPBS/IPBL do the following:
On the IPBS:
Select LAN1 > DHCP
On the IPBL: Select LAN1 > DHCP
6
In
Mode
drop-down list, change the DHCP mode from "automatic" to "client" or
"disabled"
.
7.2.2
Change the Default Password
1
Enter the IP address determined in
7.2.1 Determine the IP Address
in the web
browser address field.
2
Select General > Admin.
01
8
