USER’S MANUAL
104
NETWORK VIEWER INSTALLATION
11.8.3 PTZ
:
This menu allows you to control the PTZ camera through the network.
Click the “PTZ” button to display the following PTZ controller.
Click the
and
button to tilt up or down.
Click the
and
button to pan left or right.
Click the “ZOOM(
-
or +)” button to zoom in or out.
Click the “FOCUS(
-
or +)” button to obtain the clearest picture.
And then select the speed.
- Preset setup
: A preset is user-defined camera position using pan and tilt, zoom, and focus commands. The DVR
has programming capacity for 16 preset locations.
-
Program a preset
Move the camera to a desired position using the PTZ control buttons.
After setting the PTZ camera, click one of the desired “Set” buttons, 1~16 of Preset.
To continue setting the preset camera, click another “Set” button after
,
1
. (Repeat
,
1
and
,
2
)
-
Move to a preset
Click one of the “Move” buttons to move to the desired setting.
The camera will move to the programmed preset position.
NOTE
If you need some more information about the control keys, please refer to Chapter 5 Operation.
NOTE
You can enter the PTZ mode only while connecting the PTZ camera.
Summary of Contents for ANX-16480
Page 9: ...9 LOCATION AND CONTROL Chapter 3 Location and Control 3 1 FRONT PANEL CONTROLS 3 8...
Page 12: ...USER S MANUAL 12 INSTALLATION Chapter 4 Installation 4 1 TOTAL CONNECTION LAY OUT...
Page 41: ...USER S MANUAL 41 OPERATION You can click the below keys on the MENU screen with a mouse...
Page 91: ...91 HDD INSTALLATION PROCESS Chapter 9 256 Camera Integration system Block Diagram...
