Arris NVG599, Administrator'S Handbook

Page: 136 / 228

Administrator’s Handbook
136
set ip6 conn name name dp subnet-length value [ 0 - 16 ]
The length of the subnet portion of the delegated prefix. Default is 0 .
set ip6 conn name name dp subnet-id value [ 0 - 65535 ]
If a subnet length is specified, the value that would occupy the of the subnet portion of the connection's IPv6
prefix. Default is
0 .
set ip6 conn name name dp stay-up [ off | on ]
If the delegated prefix parameter stay-up is set to on , the global prefix assigned from the connection
delegating the prefix remains active in the event that the connection delegating the prefix goes down, and the
prefix becomes invalid. This enables local LAN-side hosts to continue to use the global prefix uninterrupted. If
parameter
stay-up is set to off , the connection's delegated prefix becomes invalid when the connection named
ipv6-conn-name delegating the prefix goes down.
Router Advertisement and DHCPv6 Server
ip6 conn (side = lan). Router advertisements and the DHCPv6 server are available on LAN-side connections
as the means to provide clients with stateful or stateless IPv6 prefixes and addresses, as well as addition client
parameters such as MTU size and IPv6-addressable DNS servers.
set ip6 conn name name radv enable [ off | on ]
The on parameter sets router advertisement to enabled for this connection.
set ip6 conn name name radv min-rtr-adv-interval seconds [ 3 - 1350 ]
The minimum time allowed between sending unsolicited multicast router advertisements from the link, in
seconds.
set ip6 conn name name radv max-rtr-adv-interval seconds [ 4 - 1800 ]
The maximum time allowed between sending unsolicited multicast router advertisements from the interface,
in seconds.
set ip6 conn name name dhcp-server enable [ off | on ]
The on parameter sets the DHCPv6 server to enabled for this connection.
set ip6 conn name name dhcp-server addr-count value [ 0 - 256 ]
The number of IPv6 addresses available to serve to DHCPv6 stateful clients. If the addr-count parameter is set
to zero, the DHCPv6 server operates in “stateless” mode.
set ip6 conn name name dhcp-server start-addr-offset value [ 0 - 65536 ]
If the
addr-count
parameter is greater than zero, the start address is an offset from the base address of the
prefix that is assigned to the LAN connection.
set ip6 conn name name dhcp-server lease-time seconds [ 180 - 8553600 ]
DHCPv6 lease time.