Arris NVG599, Administrator'S Handbook

Page: 154 / 228

Administrator’s Handbook
154
Ethernet Interfaces
set physical enet [ 1 - 4 ] mac-addr-override mac_addr
You can override your NVG599 device’s Ethernet MAC address with any necessary setting. Some ISPs require
your account to be identified by the MAC address, among other things. Enter your 12-character Ethernet MAC
override address as instructed by your service provider, for example: 12 34 AB CD 19 64
set physical enet [ 1 - 4 ] port media [ auto | 100-fd | 100-hd | 10-fd | 10-hd ]
Sets the Ethernet port’s media flow control: Automatic, 100 Mbps Full-Duplex, 100 Mbps Half-Duplex, 10 Mbps
Full-Duplex, or 10 Mbps Half-Duplex. Default is
auto .
set physical enet [ 1 - 4 ] port mdix [ auto | on | off ]
Sets the Ethernet port’s crossover detection. Default is off .
set physical enet [ 1 - 4 ] tx-queue queue_name
Attaches the egress queue template to the Ethernet interface when the queue type is egress.
set physical enet [ 1 - 4 ] rx-queue queue_name
Attaches the ingress queue to the Ethernet interface when the queue type is ingress.
set physical enet [ 1 - 4 ] port power-save enable ""
Turns power saving mode off or on.
set physical ensw max-age seconds
Sets the maximum delay on the Ethernet switch in seconds. Default is 300 (5 minutes).
set physical ensw qos-mode [ off | p-bit ]
Sets QoS up on Ethernet switch, classified by priority-bit mapping. Default is off . When p-bit is selected,
packets will be mapped from their priority (even if untagged) to one of four queues per-port in the Ethernet
switch.
See “Quality of Service (QoS) Examples” on page 217 for more information.
set physical ensw p-bit-map pbit-to-4queue-map
Sets the mapping from the 8 priority-bits to the four queues in the Ethernet switch. The lowest priority queue
is “1”, and the highest priority queue is “4”.
Example:
Mapping is “1 1 2 2 3 3 4 4", where priority bit values 0 and 1 would map to queue 1, and values 2
and 3 would map to queue 2, etc.
NOTE:
This setting only applies to packets sent from the host CPU to a switch port; it does not apply to port-to-port
traffic.