Arris NVG599, Administrator'S Handbook

Page: 120 / 228

Administrator’s Handbook
120
For example, the following CLI step command indicates that the default value is
off
and that valid entries are
limited to
on
and
off
.
option (off) [on | off]:
on
You can accept the default value for a field by pressing the Enter key. To use a different value, type it and press
Enter.
You can enter the CONFIG step mode by entering set from the top node of the CONFIG hierarchy. You can enter
step mode for a particular service by entering set service_name . In stepping set mode (press Control-X Enter)
to exit. For example:
ARRIS-3000/9437188 (top)>> set system
...
system
name (“ARRIS-3000/9437188”):
Mycroft
Diagnostic Level (High): medium
Stepping mode ended.
Validating Your Configuration
You can use the validate CONFIG command to make sure that your configuration settings have been entered
correctly. If you use the validate command, the NVG599 device verifies that all required settings for all services
are present and that settings are consistent.
ARRIS-3000/9437188 (top)>> validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
You can use the validate command to verify your configuration settings at any time. Your NVG599 device
automatically validates your configuration any time you save a modified configuration.