ARRI K2.47050.0, Instruction Manual

Page: 110 / 119

110
To clear everything, move the cursor by using the keys
Ê
and
Ë
to the line
– YES
→
Photo . Pressing the key
Í
or
Ì
sets all settings to default.
If the cursor is in position EXIT and the key
Í or Ì is pressed, the HD-IVS
will return to the Load/Store menu without setting everything to default.
Do not switch the HD-IVS or the film camera off and do not
disconnect the film camera from power supply during the update
process.
To start the update process, move the cursor by using the keys
Ê
and
Ë
to
the line – YES
→
Photo . Pressing the key
Í
or
Ì
will start the update.
If the cursor is in position EXIT and the key
Í or Ì is pressed, the HD-IVS
will return to the SERVICE Menu.
While the update process is running, status information about the update
process is displayed, e.g. DELETING I FLASH – PLEASE WAIT … or I FLASH
WRITE STATUS – 17 %
The HD-IVS will restart at the end of the update procedure automatically.
5.13.3
PIXEL CORRECTION
High definition image sensors
with a resolution of 1920 x
1080 pixels contain more than
two million individual photo
receivers. It is almost
impossible, to produce sensors
where all pixels function
correctly. There will always be
some either not light sensitive
or hyper sensitive. If the
sensitivity of the sensor is
increased, the number of
defect pixels can increase.
The state-of-the art solution to this problem is not to use the defect pixels
and reconstruct the missing information based on the neighboring pixels.
The line PIXEL CORRECTION will lead into a setup for pixel correction.
Move the cursor with the keys
Ê
and
Ë
to the line – PIXEL CORRECTION
→
Photo . The keys
Í
or
Ì
will start lead into the pixel correction menu.