ARRI ARRIFLEX 435 ES, Instruction Manual

Page: 121 / 143

121
Maintenance
screws
special key
measurement
device
hook
roller arms
Do not place your hand in the running magazine!
• To set the take-up shaft, run the camera at 24 fps. For
setting the tension of the feed shaft, the camera must run
at 24 fps reverse.
The tension measurement device should be showing
ring “5”.
• If the tension measurement device is not showing “5”,
stop the camera.
• Switch off the camera’s main switch and disconnect the
camera from the power supply.
• Place the special key ➪ photo in the holes of the friction
adjustment and turn in steps. The adjustment must lock in
at each step. When setting friction, the corresponding
winding shaft must be held firmly.
• Turn clockwise to increase friction, counter-clockwise to
decrease friction.
• Connect the camera to the power supply and switch on.
• Run the camera at 24 fps.
• Check the tension.
Note: Repeat this procedure until ring “5” is shown.
• After setting the friction, replace the tensioning plate.
• Fasten the plate with the three screws.
transparent tensioning plate