63
DE146
20. Remove the retaining nut from the front driveshaft
and remove the front drive yoke. Account for a
washer, seal, bearing, and shim.
DE147
21. Remove the retaining nut from the rear driveshaft
and remove the rear drive output coupler. Account
for a washer, bearing, and seal.
DE149
Disassembling Countershaft
NOTE: Steps 1-21 of the preceding sub-sections
must precede this procedure.
22. Remove the high driven gear; then remove the high/
low shift dog. Account for a washer and the high
driven gear bearing and bushing.
DE150A
DE191A
23. Remove the thrust washer and countershaft drive
gear from the opposite end of the countershaft.
DE150A
DE151
24. Remove the reverse dog retaining snap ring; then
remove the reverse dog and reverse dog drive bush-
ing.
Manual
Table of Contents
