152
CD681
9. Rotate the handlebar to the full-left position; then lift
and slide the panel to the rear and lift the rear up to
clear the handlebar.
CD765A
NOTE: It may be necessary to rotate the body panel
to the right to align the opening with the handlebar.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is nec-
essary.
1. Clean all fender components with a warm soap and
water solution.
2. Inspect fenders for cracks and/or loose rivets.
3. Inspect for any missing decals.
INSTALLING
1. Rotate the handlebar to the full-left position; then
place the front body panel over the handlebar and
rotate and lower into position.
CD765
2. Connect the headlight connectors to the appropriate
headlights and the front accessory plug wires to the
accessory plug.
CD681
3. Make sure the rubber grommets and bushings are in
place; then place the front rack into position and
secure with the screws and flange nuts. Tighten
securely.
4. Install one cap screw and flange nut and four plastic
rivets on each side to secure the front fenders to the
footwells. Tighten the flange nuts securely.
NOTE: If the footwells have been removed, see
Footrests in this section.
5. Install four cap screws securing the front body panel
to the frame and rear panel.
CD684A
6. Install the shift lever spring, shift lever, and pivot
axle; then tighten the axle nut securely.
Manual
Table of Contents
