146
AF677D
4. Remove the actuator arm and account for a bushing.
Note the position of the return spring for installing
purposes.
AF678D
INSTALLING
1. Place the return spring into the throttle control; then
place the bushing and actuator arm into position.
Secure with the cap screw, lock washer, and washer.
AF679D
2. Using a pair of needle-nose pliers, place the spring
into position on the actuator arm.
AF680D
3. Place the two halves of the throttle control onto the
handlebars and secure with the two machine screws.
ADJUSTING
To adjust throttle cable free-play, see Periodic Mainte-
nance/Tune-Up.
Shift Lever
REMOVING
1. Remove the left-side splash panel.
2. Remove the E-clip securing the shift rod to the shift
lever.
3. Remove the axle and nut securing the shift lever to
the upper shift arm; then remove the shift lever.
Account for a spring and two O-rings.
INSTALLING
1. Place the spring into position between the upper shift
arm and shift lever; then making sure the O-rings are
in place on the axle, secure the shift lever to the arm
with the existing axle and nut.
2. Place the shift rod into position on the shift lever and
secure with the existing E-clip.
3. Check shift lever adjustment (see Periodic Mainte-
nance/Tune-Up section); then tighten jam nut(s)
securely.
4. Install the left-side splash panel.
LCD Gauge
REPLACING
1. Remove the two reinstallable rivets securing the
instrument pod; then remove the ignition switch
retaining ring.
2. Remove the two nuts securing the mounting studs;
then remove the speedometer from the instrument
pod and disconnect the multi-pin connector.
3. Mount the speedometer in the instrument pod and secure
with the two nuts; then connect the multi-pin connector.
Manual
Table of Contents
