ZyWAN User Manual
Getting started with your ZyWAN
© 2008 Arcom Issue D
28
Initial configuration over a network
An alternate way to start the ZyWAN and perform an initial configuration is to connect it
to an existing network which also contains the configuration computer (PC).
To do this, follow the instructions below:
1
Connect ZyWAN to an existing Ethernet network and to the PC serial port. See
below.
2
Apply power to the ZyWAN. See page
29
.
3
Determine ZyWAN network address. See page
29
.
4
Configure the ZyWAN via its Web page. See page
31
.
Ethernet port ‘1’ is used in this section, which typically comes configured to
obtain its address automatically from a network. In some cases, the ZyWAN
may come factory loaded with different settings. These instructions may or
may not apply, depending on the customer configuration.
Connect ZyWAN to the network
To connect ZyWAN to the network:
1
Connect the null modem serial cable from the PC to COM1 of the ZyWAN.
2
Connect the ZyWAN network port labeled ‘1’ to an existing network, using a
standard 10base-T Ethernet cable as shown below:
Configuration PC
ZyWAN
Network Hub or Switch
RS-232 null modem
serial cable
The PC should exist on the same network. Consult a network administrator for
assistance, if necessary.
Summary of Contents for ZyWAN
Page 1: ...ZyWAN User Manual ...
