A54-3002-027
• Rev B
21
APCON, Inc.
Bypass Switch TAP/Aggregator User Manual
Chapter 3 Specifications
Port LEDs
The status LEDs for individual ports are displayed only on the Bypass TAP and are not shown
on the W
EB
XR Ports screen. Two status LEDs are provided for each Bypass TAP port on the
unit.
Compatibility
This manual describes the APCON ACI-3030-T05-1 Bypass Switch TAP/Aggregator
(Bypass TAP).
Chassis supported
This software release supports all I
NTELLA
F
LEX
XR chassis. Check the User Manual for
individual blades to determine the chassis in which each blade is supported.
When populated with I
NTELLA
F
LEX
blades, these switches allow you to aggregate, filter, and
direct data to network monitoring and analysis equipment. The software embedded in the
switch supports a browser-based graphical user interface, plus full command line and SNMP
interfaces.
Status LED
• Solid
Illuminates during power up (initialization).
• Slow blinking
Blinks during normal operations.
LEDs
Description
LEDs
Status Description
Link
Off – The port is either empty, a transceiver is not installed, or a
link cannot be established using the installed transceiver.
On – A link is established to a patch partner via the transceiver
installed in the port.
Data
Off – Port is not transmitting (TX) or receiving (RX) data.
Blinking – Port is either transmitting (TX) or receiving (RX) data.
Chassis
Description
ACI-3288-XR
8 blades, up to 288 ports total
ACI-3144-XR
4 blades, up to 144 ports total
ACI-3072-XR
2 blades, up to 72 ports total
ACI-3036-XR
1 blade, up to 36 ports total
NOTE
For any ACI-3288-XR chassis shipped before September 2014, please contact APCON
Professional Services for separate upgrade instructions.
