ANYHZ FST-500 Series, Manual, Page: 79 / 151

FST 500 Manual
- Page 79 -
Example 2 (Pr.78 = 02) Continuously executes program cycles:
The diagram below shows the PLC program stepping through each speed and then automatically
starting again. To stop the PLC program, either pause or stop the program. (Refer to Pr.38 to Pr.42
value 17 and 18)
Example 3 (Pr.78 = 03) Execute one cycle step by step:
This example shows how the PLC function can perform one cycle at a time, within a complete cycle.
Each step will use the accel/decel times in Pr.10 to Pr.13. It should be noted that the time interval for
each step may be shorter than expected due to the time required for acceleration and deceleration.