8 Performing a Measurement
50
D52IB001EN-G
8.2.5.4 Foils for the Transmission Sample Holder
Foils can be mounted in a similar way as described
in the previous chapter. In this case only the two
clamping pieces together with the foil have to be
used.
In order to be able to mount the foil correctly be-
tween the two clamping pieces, ensure that the foil
has the following dimensions: 12 x 16 mm.
8.2.5.5 Coin Cells for the Battery Sample Holder
Battery Sample Holder (Reflection):
The procedure for preparing the coin cells for the
battery sample holder (reflection) is described be-
low:
1. Place the battery sample holder together with all
necessary components for the assembly of the
battery in a glove box.
2. Remove the four screws on the lid (1) of the bat-
tery sample holder.
3. Remove the foils (2+3) and cathode (4) of the
battery sample holder.
4. Place the assembled coin cell (5) on the anode
(6).
5. Place the cathode on the coin cell.
6. Place first the Kapton foil (3) on the cathode, fol-
lowed by the graphite foil (2). (The use of the
graphite foil is optional. See also chapter 8.3.4).
7. Mount the lid (1) of the battery sample holder
again by the use of the 4 Torx screws.
An exploded-view drawing showing all the compo-
nents (including the assembled coin cell) is shown
below.
Fig. 52: Exploded-view drawing of the battery sample
holder (reflection)
1 Lid of holder
2 Foils: graphite
3 Cathode
4 Coin cell
5 Anode
6 Isolation inlet
7 O-ring
8 Basis
9 Electrode contacts
After the complete assembly of the battery sample
holder, the sample holder can be extracted from the
glove box and mounted on the heater of TTK 600
(see chapter 8.4.6 for further details).
NOTICE
Risk of damage.
When closing the battery sample holders ensure
that the cathode is correctly aligned in the slot in
the sample holder base. Rotate and visually
inspect the sample holder after closing to ensure
there are no gaps between the sample holder
base and the lid. Not closing the sample holder
correctly can lead to problems aligning the sam-
ple.
1
2
3
4
5
6
7
8
10
9
11
Summary of Contents for TTK 600
Page 2: ......
Page 74: ...Appendix B Sample Chamber Dimensions 74 D52IB001EN G Appendix B Sample Chamber Dimensions ...
Page 75: ...Appendix C Declaration of Conformity D52IB001EN G 75 Appendix C Declaration of Conformity ...
Page 77: ...Appendix D Spare Parts and Accessories D52IB001EN G 77 176383 COOLING MODE SWITCHING VALVE ...
