Expansion Functions
MS2830A-010/110 Phase Noise Measurement Function/Retrofit
Phase Noise Measurements
Frequency Range: 10 MHz to main-frame upper limit frequency
Offset Frequency Range: 10 Hz to 10 MHz
MS2830A-017/117 Noise Figure Measurement Function/Retrofit
Adds noise figure measurement function.
Noise Figure is measured with the measurement method of
Y-factor method which uses a Noise Source.
MS2830A-026/126 BER Measurement Function/Retrofit
Adds BER measurement function.
It supports Rx sensitivity tests by inputting the receiver-demodulated
Data/Clock/Enable to the back of the MS2830A.
Input Bit Rate: 100 bps to 10 Mbps
Input Level: TTL
Connector: Rear panel, AUX connector
∗
∗
: Can convert to BNC by connecting AUX Conversion Adapter (J1556A).
MS2830A-020/120 3.6 GHz Vector Signal Generator/Retrofit
Cover frequency ranging from 250 kHz to 3.6 GHz with 120 MHz
wideband vector modulation bandwidth
MS2830A-021/121 6 GHz Vector Signal Generator/Retrofit
Cover frequency ranging from 250 kHz to 6 GHz with 120 MHz
wideband vector modulation bandwidth
MS2830A-022/122
Low Power Extension for Vector Signal Generator/Retrofit
Extends lower limit of output level from –40 to –136 dBm
(Note: 5-dB drop in upper output level)
MS2830A-027/127
ARB Memory Upgrade 256 Msa for Vector Signal Generator/Retrofit
Extends ARB memory capacity from 64 Msample to 256 Msample
MS2830A-028/128 AWGN/Retrofit
AWGN generator function
MS2830A-313 Removable HDD
The MS2830A-313 Removable HDD is useful when a user takes
the instrument to an outside company for calibration but wants to
protect the security of data in the instrument, such as measurement
results, data and main frame settings. In this case, the user
removes the regular MS2830A hard disk and replaces it with this
product.
MS2830A-029
Analog Function Extension for Vector Signal Generator
Adds analog signal generation function using MX269018A Analog
Measurement Software to Vector Signal Generator option (Opt.
020/021). Can calibrate lower limit frequency up to 100 kHz (Opt.
020/021 lower limit frequency is 250 kHz)
∗
: Requires MX269018A, Opt. 020 or 021, and Opt. 022
MS2830A-088/188 3.6 GHz Analog Signal Generator/Retrofit
Outputs analog signals by combining with MX269018A Analog
Measurement Software and includes low power expansion
(equivalent to Opt. 022).
Can calibrate lower limit frequency up to 100 kHz (Opt. 020/021
lower limit frequency is 250 kHz)
∗
: Requires MX269018A
∗
: Vector modulation signal output not supported (added by Opt. 189)
MS2830A-189
Vector Function Extension for Analog Signal Generator Retrofit
Installs license required for vector signal generation in existing
Analog Signal Generator (Opt. 088/188).
Use following options when ordering new Analog Signal Generator
+ Vector Signal Generator:
•
Opt. 020 or 021 + Opt. 022 + Opt. 029 + MX2 Opt. 066 + A0086A
28
Product Brochure
l
MS2830A
