Anritsu 680XXC, Operation Manual, Page: 119 / 241

Press SS Mode to place the signal generator in a
source lock mode for operation with a Anritsu Model
360B Vector Network Analyzer. (Refer to paragraph
7-4 for information pertaining to operating the
681XXC with a 360B VNA.) Press
SS Mode again
to turn the source lock mode off.
Press More to go to the First Additional Configure
GPIB menu for more selections.
Press Previous Menu to return to the System Con-
figuration Menu display.
First Additional Configure GPIB Menu
When you press
More the First Additional Config-
ure GPIB Menu (below) is displayed.
This menu lets you perform the following:
q Select the model and set the GPIB address for
the power meter that is used to create a user
level flatness correction power-offset table.
(Refer to page 3-67 for a description of the
function.)
q Select the external interface language for re-
mote operation of 681XXCs with Option 19.
(Refer to page 2-9 for more information.)
Press Pwr Mtr Address to change the address of the
power meter on the GPIB (the power meter’s default
GPIB address is 13). Enter a new address, between
1 and 30, using the cursor control key or the data
entry keypad and the terminator key
Hz
ns
ADRS
The new GPIB address will appear on the display.
Press Pwr Mtr Select to select the power meter
model being used. (Supported power meters are the
Anritsus ML2437A, ML2438A, and ML4803A and
Hewlett-Packard 437B, 438A, and 70100A.)
3-86 681XXC OM
LOCAL (FRONT SYSTEM
PANEL) OPERATION CONFIGURATION
SS MODE
When SS Mode is selected on, this
message is displayed (in the fre-
quency mode title bar) on all menu
displays to remind the operator
that the 681XXC is in a source lock
mode.