Anita Garudan GF-1105 Series, User Manual, Page: 15 / 77

ANITA ©
MP01100EN_161101 15
13) HAND LIFTER
1. To stop the machine with its presser foot
up, turn hand lifter 1 in direction „A“
2. The presser foot will go up about 5.5mm
and stop
3. The presser foot will go back to its original
position when hand lifter is turned down in
direction „B“
4. Using the knee lifter, you can get the
standard presser foot lift of about 10mm
and the maximum lift of about 13mm.
Fig.20
14) STITCH LENGTH ADJUSTMENT
As is shown in Fig.21, the number marked by the
stitch adjusting dial (1) signifies the stitch length in
mm units. Move the dial sideways to set it to the
desired stitch length (Turn it in clockwise direction
and the stitch length will decrease while turning it
counterclockwise will increase the stitch length).
Fig.2 1
15) HEIGHT AND INCLINATION ADJUSTMENT OF FEED DOG
A. Height adjustment of the feed dog
The height of the feed dog is adjusted by moving the lifter crank (1) after the lifter crank fixing screw
(2) is loosened. The standard height from the top face of the needle plate to the top of the feed dog
when the stitch length dial is at its maximum and the feed dog is at its highest point is shown in
Fig.22.
Fig.22
www.garudan.cz