Anita Garudan GF-1105 Series, User Manual, Page: 14 / 77

ANITA ©
MP01100EN_161101 14
11) ADJUSTMENT OF HEIGHT AND PRESSURE OF PRESSER FOOT
A. AS is Fig.18, remove the rubber plug (2)
in the face plate and place the presser
foot (3) on the needle plate. Then,
loosen the presser bar fixing screw (4)
and adjust the height of the presser bar.
The presser foot lifter (3) will fall when
the presser bar is lifted and rise when
the presser bar is moved down. Move
the presser foot lifter (5) manually to
place the bottom face of the presser
foot 5,5 mm above the top face of the
needle plate and tighten the presser bar
fixing screws firmly.
B. The tension of the presser foot will grow
stronger when the tension adjusting
screw (6) is turned clockwise and turned clockwise and weaker when turned counterclockwise.
Make sure to screw in the fixing nut (1) after adjustment. (Fig .18 )
C. Loosen set screw (1) and adjust the
presser bar height or the angle of the
presser foot. After adjustment, securely
tighten the setscrew.
Fig
. 18a
12) AUTOMATIC PRESSER FOOT LIFT HEIGHT ADJUSTMENT
Atte ntion: Turn the power - off before
installation in order to avoid any accident or
damage.
1. When the pull rod 1 fixed on hole A of
lever 2, the foot lifter height is 12mm
2. When the pull rod 1 fixed on hole B of
lever 2, the foot lifter height is 10mm
3. When the pull rod 1 fixed on hole C of
lever 2, the foot lifter height is 7mm
Fig . 19
Fig. 18
www.garudan.cz