AngioDynamics NanoKnife, User Manual, Page: 65 / 91

65
160-104694 Rev 01
Version 2.2.0
At the end of the procedure, a pop-up panel may appear on the screen, showing events that
may have occurred during the procedure. In particular, the following error messages may
appear:
An error message indicating that the procedure between specified electrode
probes has been interrupted due to excessive current.
An error message indicating that the current measured during the procedure
between the specified electrodes was very low. In this case, verify whether the
electrode probes are correctly connected to the Generator, i.e., each electrode
probe to the proper output connector on the front panel of the Generator.
For a complete list, go to Section 8.3 Generator Error Messages.
NOTE: Overlooking the above errors may result in ineffective ablation.
To view the Result Graphs screen, select the "Result Graphs" tab in the upper left corner of
the screen (Figure 5-51). The Result Graphs screen consists of the
Complete Procedure
Voltage Results graphs
and
Complete Procedure Current Results graphs
for all pulses of
the procedure
.
The lower sections of the screen do not change when moving from the
Procedure Parameters screen to the Result Graphs screen.
Figure 5-51: Pulse Generation Screen with Result Graphs Sub-Screen Shown