AngioDynamics NanoKnife, User Manual, Page: 28 / 91

28
160-104694 Rev 01
Version 2.2.0
• Connect the plug to a main outlet with protective ground.
• Turn ON the Generator via the
Main switch
of the
Power Supply Group
, located
on the power unit’s back panel. The system is ON when the main switch is
pressed in "I" position. When the switch is pressed in the "O" position, the
device is OFF.
4.2 Generator Start-Up and Warm-Up
To start up the system proceed as described below:
a. Move the
Main
switch located at the back panel of the power unit to position
"I". The Green
Power-ON
indicator on the front panel lights up, while the
console starts loading the operating system.
b. Allow about 10 seconds for the video signal to appear on the LCD display.
c. Check that the
STOP
button status Indicator , on the Generator’s front panel,
is lit Green. If not lit, rotate the Stop button knob clockwise, as indicated on
the knob to release the
Stop
button.
d. The operating system will automatically begin its start-up process and self
checks. It will run through the following self checks before the User is able to
begin the procedure process:
•
Initializing Device
•
Checking Connections
•
Checking Status
•
Checking Memory
•
Device Setup
•
Testing Charge
•
Test Delivery
A screen will display each check’s progress until the Generator completes the
Start-up self test and all checks pass successfully, see Figure 4-1 and Figure
4-2.
Figure 4-1: Start-Up Screen in Progress