Angelo Po FX101 G 2, Installation And Operation Manual

Page: 48 / 132

48
Combination Oven Installation and Operation Manual
Section 8
Troubleshooting
KEY TO ALARM TABLE
Alarm Fault Remedy Notes
H2O
1RZDWHULQFKDPEHURU
water pressure too low
Check that mains water is
SUHVHQWRUDGMXVWWKHSUHVVXUH
VHHSDJHLIWKHSUREOHP
persists call an authorized
service agent
Convection cooking cycles can still
be performed
H2O.
1RZDWHUDWGUDLQRUZDWHU
pressure too low
Check that water supply is
SUHVHQWRUDGMXVWWKHSUHVVXUH
VHHSDJHLIWKHSUREOHP
persists call an authorized
service agent
Convection and steam cooking
cycles can still be performed
GAS
1RPDLQVJDVJDVSUHVVXUH
WRRORZRUÀDPHGHWHFWLRQ
failure
Press reset button (the button
may have to be pressed
VHYHUDOWLPHVLIWKHSUREOHP
persists call an authorized
service agent
Stop cooking if this message is
repeated more than once
OPE Oven door opening or
closure request Open or close the oven
GRRU&DOODQDXWKRUL]HG
service agent if this message
continues to be displayed
The cooking cycle does not start
until the door has been opened or
closed as required
CLE Indicates that cleaning is
required
/DXQFKDQDXWRPDWLFFOHDQLQJ
cycle
The oven’s functions are enabled;
cooking cycles can be performed
E01 The cooking chamber probe
has failed or is not properly
connected Call an authorized service
agent The oven’s functions are disabled;
no cooking cycles can be
performed
E02 The core probe has a failure
or has not been properly
connected Check the position of the
product core probe or call an
authorized service agent if it is
faulty Cooking cycles with product core
probe cannot be performed
E03 The steam discharge probe
has failed Call an authorized service
agent Convection and steam cooking
cycles can still be performed
E04
7KHPRWRURSHUDWHGYDOYHLV
not positioned correctly
Switch on the oven again and
if the problem persists call an
authorized service agent Convection and steam cooking
cycles can still be performed
E05 Safety thermostat failure Call an authorized service
agent The oven’s functions are disabled;
no cooking cycles can be
performed
E06 Overload cutouts tripped Call an authorized service
agent The oven’s functions are disabled;
no cooking cycles can be
performed
E07 Overload cutouts tripped Contact an authorized service
agent The oven’s functions are disabled
so no cooking cycles can be
performed
E08 The optional vacuum probe
has failed or is not properly
connected Press the “Reset” button Disconnect and reconnect the
vacuum probe before starting
the cooking cycle. If the problem
SHUVLVWVFDOODQDXWKRUL]HGVHUYLFH
agent