Copyright © 2015 Shenzhen ANB Technology Co., Ltd. All rights reserved.
Image and RFID reader etc, please refer to those dedicated instruction document which will be
available from ANBTEK.
The TS100W mainframe installation, the installer only needs to consider:
Get power supply from Vehicle which is necessary with permanent supply. Which means even
with engine off, it still can get power supply from this connection;
Connect ACC wire to ignition switch signal wire. This wire has to be with Ignition status ON/Off
status. And this wire is a must connection which will make TS100W work properly like data
report interval, Sleep mode activate and deactivate etc.
Door status detection wiring. It should connect to the door signal wire which can reflect the door
close/Open status.
For Door Lock/Unlock control, the extra relay will be necessary for installation. Because TS100W
only get Digital output control signal.
4 FIRMWARE
ANBTEK always try to improve the TS100W performance by perfect the firmware.
TS100W firmware upgrading only support via Micr-USB mode. And not supported with
“Wireless upgrading by Air GPRS communication.”.
Firmware Upgrading via MICRO-USB with PC connected will need following necessities:
-
USB cable connect TS100W with PC
-
Open TS100W Box and locate the Run->ISP MCU mode switch
-
Firmware upload software “MCUISPSTM.exe”
-
Firmware provided by ANBTEK.
More detail operations please refer to “TS100W Firmware Upgrading Instruction” document.
5 OPERATIONAL BASICS
5.1 Operational Principals
