Copyright © 2015 Shenzhen ANB Technology Co., Ltd. All rights reserved.
3) General Parameter:
•Memory Record Interval:
In TS100W device has an internal memory of 4MB which is used for recording
traveling way points when GPRS is not connected with server.This memory record
interval is time based.
•Memory Record Report:
For those GPRS null zone data, when vehicle is ACC Off, it will send all of them
back to server. So there will be no blind zone for server database about vehicle travel
history. By ON/Off this function to configure if device need send those data to server.
Factory default setting is ON.
•Incoming Call Pickup:
TS100W has intercom audio talking function. By this setting allow the device
pickup all incoming call or not.
•Time Zone:
TS100W use GPS factor time as data time. And normally it's GMT time. By setup
this time zone to make the SMS data time as vehicle local time. But all data go to Server
still use GMT time. ANBTEK Server will recognize and convert the time to be vehicle's
local time.
•Work Mode:
TS100W has two working modes: 1.SMS only;2.SMS+GPRS mode.
In SMS working mode, even device was configured APN, IP and port, it will never
connect Server.
In SMS+GPRS mode, if GPRS is disconnected, device will switch to use SMS send data
automatically
4) Sleep Setting When ACC Off
•Data Send Interval:
This interval is with time based. Means when ACC Off, device sends data to server
every xxx seconds.
•No Sleep:
No sleep means device is all full working. GPS receiver keep searching signal all the
time and 3G/4G is online with server always.
•Simple Sleep:
GPS receiver is shut down. GPRS is disconnected, but 3G/4G is standby like
receive/send SMS and calls.
Any alarm event will wake up device to be alive as normal.
•Deep Sleep:
GPS Receiver is shut down. GPRS is disconnected; No SMS and Calls cannot be reachable.
