Copyright © 2015 Shenzhen ANB Technology Co., Ltd. All rights reserved.
TS100W device is designed to acquire GPS and I/O information in live and send them to server
via 3G/4G network.
It uses GPS receiver to acquire GPS data and is powered with data acquire methods: Time-based,
distance-based, angle-based and various I/O event trigger. All data acquired will send to server in
real time via GPRS or SMS.
At the same time, the device will keep those data records in internal memory with a preset time
interval which you can retrieve upon command request via GPRS only. GPRS mode is most
preferred data sending mode. SMS mode is mostly used in areas without GPRS coverage of GPRS
usage is too expensive.
GPRS and SMS setting will be described in GPRS configuration section. TS100W communicates
with server use special data protocol, and the protocol is described in " TS100W Air Traffic
Communication protocol' document.
The TS100W can be managed by SMS Commands also. SMS command list is described in SMS
command list section.
Module configuration can be performed over TCP, or via SMS, or via ComPort configurator
software tool. If it’s with external display connected, the display also can do configurations.
5.2 Sleep mode
TS100W get sleep mode design which in purpose to save power consumption and Data Stream
when considered as not necessary to be active.
The module will enter sleep mode under two conditions:
1) Vehicle engine is off for more than 10Minutes
2) Device configuration has activated sleep mode.
TS100W has 2 stage sleep level:
1) Simple sleep:
In this level with GPS receiver to sleep, therefore it does not record or send any live
co-ordinates but with I/O detection alive, the power usage also decreases allowing saving
vehicle battery.
2) Deep Sleep:
In this sleep mode, both GPS receiver and 3G/4G module will go to sleep. Module cannot
receive any call or SMS, and will not update co-ordinates too. And the power consumption
will go to be very low levels (15-20mA).
The user can configure a proper sleep mode according to individual favorites.
TS100W will exit sleep when:
Any alarm events including ACC ON, Vibrations and Power tamper will wake device to normal