Analytik Jena CyBio Well vario OL3381-25-300, Operating Manual

Page: 98 / 164

82 Release: 2017 CyBio
®
Well vario
Operation
Piston speed:
Piston speed (pumping rate) is a selectable parameter. This setting will only be effective
in manual mode, since programs running in PC-controlled mode include their own pre-
viously stored pump speed values. A rotation speed of 300 r.p.m. corresponds to an ap-
proximate dispensing rate of 123 μ l/s achieved with a 250 μ l pipetting head or a
12.3 μ l/s rate achieved with a 25 μ l pipetting head.
You can enter an end value for motion speed here. Software settings can be made for
end speed, or starting speed and end speed or for the motion characteristic.
Table speed
A table speed setting will be valid for lifter motion and carriage and rotary table motion.
You can enter an end value for motion speed here. Software settings can be made for
end speed, or starting speed and end speed or for the motion characteristic.
Click
Allows you to set an acoustic click for confirmation of each keystroke. You can switch
the click on and off.
CAUTION
In the case of excessively high carriage or rotary table motion speed, there may be over-
flow of liquid from the reagent troughs. Select a reasonably reduced speed value if nec-
essary.
NOTE
In manual mode, lifter motion is limited to a maximum speed of 17 mm/s (60 r.p.m.).
This is necessary to enable a more precise height setting. In program-controlled (com-
puter-controlled) mode, the limiting value is around 40 mm/s (140 r.p.m.).