![background image](http://html1.mh-extra.com/html/amx/tango-das-t0804-sig/tango-das-t0804-sig_operation-reference-manual_2937921029.webp)
Installation
17
Tango Series Audio Controllers
Tone Control & SRS Setting
To access the Tone Control and SRS settings, press the TONE button. This enables the Tone Control Mode
with BASS as the first mode selected. There are 3 Tone Control Modes available for adjustment, and 4 SRS
options, as follows:
BASS: Increase / Decrease from -10dB to +10dB (Up/Down NAV buttons)
Treble: Increase / Decrease from -10dB to +10dB (Up/Down NAV buttons)
Balance: Left / Right (Up NAV button = right, Down NAV button = left)
SRS options: BASS Boost, Focus, 3D, WOW
The Source buttons on the Metreau keypad provides visual feedback as to which mode it is currently in. The
following sources will light based on the current mode:
Source 1 = BASS
Source 2 = Treble
Source 3 = Balance
Source 4 = SRS
When first entering Tone Control Mode, BASS mode is active (Source 1 LED is lit). To move from mode to
mode, select the Center NAV button. This saves the setting and moves to the next mode.
Note
: While in each of the modes, press and hold the Center NAV button to return to the default for that mode.
SRS (Bass Boost, Focus, 3D and WOW) Settings
Use the UP Nav button to cycle through the SRS Settings: BASS Boost, Focus, 3D, WOW (in that order).
Use the Down NAV button to cycle backwards to the previous SRS setting.
Press and hold the Center NAV button to disengage/clear the SRS settings (none of the SRS modes
will be engaged).
Press the Center NAV button to save SRS Mode & exit from Tone Control
set-up.
Only one SRS mode can be engaged per room/zone. Each room/zone, however, can have a different SRS
mode.
The Volume LED's are used to provide feedback as to which SRS setting is active:
No LED = SRS Off
LED1 = BASS boost
LED 1&2 =Focus
LED 1,2&3 =3D
LED 1,2,3&4 =WOW
Moving from one SRS position to another disengages the original setting i.e. moving from WOW to BASS
BOOST, disengages WOW.
Zone Control
To turn a single Zone ON
, press any Source button (or press the Power
Button).
Note
: If the Power button is pressed, the zone will turn ON and will remember which source was
previously ON.
To turn a single Zone OFF
, press the Power button.
To turn a specific Source ON in all Zones
, press and hold any Source button (the selected source
will turn on and play in all zones).
To turn a specific Source OFF in all Zones
, press and hold the active Source button.
To Turn All Zones OFF (System OFF)
, Press the "OFF" button. All zones will be turned off, and
no sources will play.
Note
: One minute after an ALL OFF has been performed, the Controller and all Sources will be
powered down
Note
: Pressing Source Buttons switches between sources and turns the Source On, but does not
toggle between ON and OFF.
Summary of Contents for Tango DAS-T0804-SIG
