![background image](http://html.mh-extra.com/html/amx/dvx-21xxhd/dvx-21xxhd_webconsole-and-programming-manual_2937827096.webp)
Terminal (Program Port/Telnet) Commands
96
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
Terminal Commands (Cont.)
Command
Description
SET THRESHOLD
Sets the Master's internal message thresholds. This command will set the thresholds of when
particular tasks are pended. The threshold is the number of messages queued before a task is
pended.
Use extreme caution when adjusting these values.
Note: The Master must be rebooted to enable new settings.
Example:
>SET THRESHOLD
-- This will set the thresholds of when particular tasks are pended. The
threshold is the number of messages queued before a task is pended.--
--Use extreme caution when adjusting these values.--
Current Interpreter Threshold = 2000
Enter new Interpreter Threshold (Between 1 and 2000)(Default=10):
Once you enter a value and press the ENTER key, you get the following message:
Current Lontalk Threshold = 50
Enter new Lontalk Threshold (Between 1 and 2000)
(Default=50):50
Current IP Threshold = 600
Enter new IP Threshold (Between 1 and 2000)
(Default=200): 600
Setting Thresholds to: Interpreter 2000
Lontalk 50
IP 600
New thresholds set, reboot the Master for the changes to take effect.
SET TIME
Sets the current time. When the time is set on the Master, the new time will be reflected on all
devices in the system that have clocks (i.e. touch panels). By the same token, if you set the time on
any system device, the new time will be reflected on the system’s Master, and on all connected
devices.
Note: This will not update clocks on devices connected to another Master (in Master-to-Master
systems).
Example:
>SET TIME
Enter Date: (hh:mm:ss) ->
SET TIMELINE LOOPCNT
Sets the Master's timeline/event max loopcount.
SET UDP BC RATE
Sets the UDP broadcast rate. A broadcast message is sent by the Master to allow devices to
discover the Master. This command allows the broadcast frequency to be changed or eliminate the
broadcast message.
Example:
>SET UPD BC RATE
Current broadcast message rate is 5 seconds between messages.
Enter broadcast message rate in seconds between messages
(off=0 ; default=5) (valid values 0-300):
Once you enter a value and press the ENTER key, you get the following message:
Setting broadcast message rate to 300 seconds between messages
New broadcast message rate set.
SET URL <D:P:S>
Sets the initiated connection list URLs of a device. Enter the URL address and port number of
another Master or device (that will be added to the URL list).
• Enter Y (yes) to approve/store the new addresses in the Master.
• Enter N (no) to cancel the operation.
Example:
>SET URL [0:1:0]
No URLs in the URL connection list
Type A and Enter to Add a URL or Enter to exit.
> a
Enter URL -> 192.168.21.200
Enter Port or hit Enter to accept default (1319) ->
Enter Type (Enter for permanent or T for temporary) ->
URL Added successfully.