![background image](http://html.mh-extra.com/html/amx/dvx-21xxhd/dvx-21xxhd_webconsole-and-programming-manual_2937827089.webp)
Terminal (Program Port/Telnet) Commands
89
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
Terminal Commands (Cont.)
Command
Description
MEM
Displays the largest free block of the Master’s memory.
Example:
>MEM
The largest free block of memory is 11442776 bytes.
MSG ON|OFF
Enables/Disables extended diagnostic messages.
• MSG On [error|warning|info|debug] sets the terminal program to display log messages
generated by the Master. The level of log printed to the terminal window depends both on the
level used when sending the message and the output level selected with "msg on." For example
if log output is enabled via "msg on warning" then logs produced at levels AMX_ERROR and
AMX_WARNING will be displayed, but not logs produced at levels AMX_INFO or AMX_DEBUG. The
order of severity from highest to lowest is ERROR, WARNING, INFO, DEBUG. If no severity is
supplied with "msg on", the default setting is WARNING.
• MSG OFF disables the display.
Example:
> MSG ON
Extended diagnostic information messages turned on.
> MSG OFF
Extended diagnostic information messages turned off.
MSG STATS
Calculates incoming and outgoing messages over a time interval.
NETLINX LOG LEVEL
Configure the current setting for the NetLinx AMX_LOG facility.
Example:
>netlinx log level
NetLinx Log Level is WARNING
Set NetLinx Log level to :
1) ERROR
2) WARNING
3) INFO
4) DEBUG
Enter selection or press return to keep current level:
>3
NetLinx Log Level set to INFO
OFF [D:P:S or NAME,CHAN]
Turns off a specified channel on a device. The device can be on any system that the Master you are
connected to is able to reach. You can specify the device number, port, and system, or the name of
the device that is defined in the
DEFINE_DEVICE
section of the program.
Syntax:
OFF[name,channel]
-or-
OFF[D:P:S,channel]
Example:
>OFF[5001:7:4]
Sending Off[5001:7:4]
ON [D:P:S or NAME,CHAN]
Turns on a specified channel on a device. The device can be on any system that the Master you are
connected to is able to reach. You can specify the device number, port, and system, or the name of
the device that is defined in the
DEFINE_DEVICE
section of the program.
Syntax:
ON[name,channel]
-or-
ON[D:P:S,channel]
Example:
>ON[5001:7:4]
Sending On[5001:7:4]