![background image](http://html.mh-extra.com/html/amx/dvx-21xxhd/dvx-21xxhd_webconsole-and-programming-manual_2937827092.webp)
Terminal (Program Port/Telnet) Commands
92
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
Terminal Commands (Cont.)
Command
Description
SET ETHERNET MODE <CMD>
This command sets the current LAN configuration.
• <CMD> = "auto"
or
<speed> <duplex> where
<speed> = 10 | 100 and <duplex> = full | half
Examples:
Set Ethernet mode auto
Set Ethernet mode 100 full
Set Ethernet mode 10 half
When new mode is set, unit will respond with:
Ethernet mode set. Change takes effect after reboot.
Note: See the GET ETHERNET MODE
.
SET FTP PORT
Enables/Disables the Master’s IP port listened to for FTP connections.
Note:
The Master must be rebooted to enable new settings.
Example:
>SET FTP PORT
FTP is enabled
Do you want to enable (e) or disable (d) FTP (enter e or d):
FTP enabled, reboot the Master for the change to take effect.
SET HTTP PORT
Sets the Master’s IP port listened to for HTTP connections.
Note:
The Master must be rebooted to enable new settings.
Example:
>SET HTTP PORT
Current HTTP port number = 80
Enter new HTTP port number (Usually 80) (0=disable HTTP):
Setting HTTP port number to
New HTTP port number set, reboot the Master for the change to take effect.
SET HTTPS PORT
Sets the Master’s IP port listened to for HTTPS connections.
Note:
The Master must be rebooted to enable new settings.
Example:
>SET HTTPS PORT
Current HTTPS port number = 443
Enter new HTTPS port number (Usually 443) (0=disable HTTPS):
Once you enter a value and press the ENTER key, you get the following message:
Setting HTTPS port number to
New HTTPS port number set, reboot the Master for the change to take effect.
SET ICSP PORT
Sets the Master’s IP port listened to for ICSP connections.
Note:
The Master must be rebooted to enable new settings.
Example:
>SET ICSP PORT
Current ICSP port number = 1319
Enter new ICSP port number (Usually 1319)
(0=disable ICSP):
Once you enter a value and press the ENTER key, you get the following message:
Setting ICSP port number to
New ICSP port number set, reboot the Master for the change to take effect.
SET ICSP TCP TIMEOUT
Sets the timeout period for ICSP and i!-Web Control TCP connections.
Note: The new timeout value is immediately (no reboot required).
Example:
>SET ICSP TCP TIMEOUT
This will set the timeout for TCP connections for both ICSP and i!-Web
Control.When no communication has been detected for the specified number of
seconds, the socket connection is closed.ICSP and i!-Web Control have built-in
timeouts and reducing the TCP timeout below these will cause undesirable
results. The default value is 45 seconds.
The current ICSP TCP timeout is 45 seconds
Enter new timeout (in seconds):
Once you enter a value and press the ENTER key, you get the following message:
New timeout value set (in affect immediately).