S-Video Boards
63
Modula Instruction Manual
Attaching Cables
Important:
If using Cat5 compatible S-Video boards –
for information on installation and system setup,
first see “Cat5 Video and Audio Boards with TXs and RXs” starting on page 123.
When attaching S-Video input and output cables, refer to the sheet labeled “AutoPatch Modula Connector
Guide” that ships with the system. The sheet shows you where to attach each cable on the rear of each
enclosure. Follow the sheet exactly; the system was programmed at the factory to operate
only
as indicated
on the sheet. For multiple-enclosure systems, each enclosure will be numbered (e.g., “Chassis 1 of 3”) on a
label located on the left side (near the power receptacle).
Attaching S-Video Cables
Modula S-Video boards are equipped with locking S-Video connectors. When used in conjunction with an
AMX AutoPatch manufactured S-Video cable, the connector and the cable lock into place. Standard
S-Video connectors may be used, but will not lock.
To connect S-Video inputs and outputs:
1.
Fasten the cables onto the input and output S-Video connectors (FIG. 31).
Caution:
To avoid damaging a locking S-Video connector or board, be sure to pull on the connector
housing instead of the cable
.
To fasten a locking S-Video connector:
1.
Hold the connector at a slight angle to the right while pushing in.
Or
Pull back on the housing of the connector (FIG. 32) while pushing the connector in.
To remove a locking S-Video connector:
1.
Pull back on the housing of the connector.
FIG. 31
Fasten S-Video cable onto connector
FIG. 32
Pull back housing to fasten connector
IN
11
10
9
12
IN
15
14
13
16
8
IN
7
6
5
IN
3
2
1
4
Connector housing
Summary of Contents for AutoPatch Modula
