AMX AutoPatch Modula, Instruction Manual, Page: 141 / 191

Cat5 Video and Audio Boards with TXs & RXs
135 Modula Instruction Manual
I mportant: To determine the correct wiring to use for the audio connectors, check the type of
connectors specified under each module illustrated in the figure on page 124 and in the table for
AF-10 boards on page 125. If the model is listed for balanced audio, it may also be wired for
unbalanced audio (FIG. 90
). If the model is listed for unbalanced, it can only be wired for unbalanced
(FIG. 91).
3.
Attach 3-position terminal block audio wires:
Unscrew the clamps on the audio connector.
Insert the wires (FIG. 90 or FIG. 91) and firmly re-tighten the clamps to make secure connections.
Note: When using twisted pair wire, connect the shield (ground) at one end only (recommend
receiving end) to minimize low frequency noise.
4.
Apply power to the system. The electrical ratings must meet those indicated in the specifications
table (see page 126).
AF-10 – Plug the AC power cord into the power receptacle and into the external power source.
Module – If you are using the AMX AutoPatch power supply, plug the desktop power supply into
the power jack on the module(s) and into an AC external power source.
Or
If you are providing the power supply, plug the power cord from a UL (or equivalent) listed power
supply into the power jack on the module(s).
FIG. 90
Wiring options for models with 3-position balanced audio connectors
FIG. 91
Wiring for models with 3-position unbalanced audio connectors
Balanced Wiring
Unbalanced Wiring
Unbalanced Wiring