AMX AutoPatch Modula, Instruction Manual, Page: 93 / 191

RGBHV+Stereo to CatPro Boards with TXs & RXs
87 Modula Instruction Manual
To adjust the video display using the CatPro Wizard:
1.
Connect the monitor that was reserved for calibration to any one of the HD-15 outputs.
2.
Route the source being calibrated to the HD-15 output (destination).
3. On the Source PC, open the test image file from the AMX AutoPatch CD whose resolution
corresponds to the highest source resolution used in the system.
The test image appears on the Destination Monitor (the image will be distorted).
4. On the Control PC, open the CatPro Wizard.
5.
In the Wizard, select the source in the navigation tree in the upper left corner that corresponds to the
input connector number for the source signal to be adjusted.
6.
If the Destination Monitor’s brightness needs to be increased or decreased, select the Gain icon and
move the slider until the desired brightness is reached.
7. If the picture is not sharp enough, select Peak and move the slider until the desired sharpness is
reached. (Increasing the peak removes the graininess; over peaking can result in the picture going
blank.) The image will still be skewed.
FIG. 52
Test image on Destination Monitor with distorted display
FIG. 53
Select the source to be adjusted
FIG. 54
Test image adjusted for gain and peak (image is still skewed)
Select the source