Installation and Setup
35
Modula Instruction Manual
Caution:
To avoid system damage, follow the power-up sequence on page 38. We recommend
attaching all power cords to a surge protector and/or AC line conditioner.
To complete establishing external serial control
3.
If not already on, apply power first to the Modula enclosure and then to the source and destination
devices (see “Applying Power and Startup” on page 38).
4.
Set up and run the desired method of control:
AMX Control Devices
– see the documentation for the specific control device.
APControl 3.0
– Install and open the program from the
AMX AutoPatch CD
(if your account
has the required permissions, this program can be downloaded from
www.amx.com
).
Follow the setup wizard and open the APControl Launchbar.
Terminal emulation (HyperTerminal)
– Open the program, select the COM port, and check
that the settings match those in the Modula Serial Port Settings table (see previous page).
If the COM port settings do not match, enter the applicable values from the table.
Click OK.
A short splash screen appears.
5.
Execute a test switch to ensure the Modula is working properly (see “Executing a Test Switch” on
page 41).
Summary of Contents for AutoPatch Modula
