AMX AutoPatch Modula, Instruction Manual, Page: 178 / 191

Appendix D – Adding or Replacing Boards
172 Modula Instruction Manual
Removing Blank Board Plates or Boards
To remove a blank board plate or a current Modula board:
1.
Remove the two screws indicated from the top and bottom of the board plate (FIG. 109).
2. Blank board plate – Remove the plate covering the empty expansion slot.
Current board – Remove the plate covering the board being replaced.
If the current board is an audio board, first unplug the 3 or 5-terminal connector from the board,
then remove the board plate.
If the new board is the same type as the replacement board, set the plate and its screws aside for
reuse.
3.
Current board – Carefully pull the board straight out of the board slot and place in an ESD approved
static shield bag.
FIG. 109
Remove screws from empty board slot or current board
+
+