AMX AutoPatch Modula, Instruction Manual, Page: 90 / 191

RGBHV+Stereo to CatPro Boards with TXs & RXs
84 Modula Instruction Manual
4.
If the picture is not sharp enough, turn the Peak potentiometer. (Increasing the peak removes the
graininess.) The image will still be skewed.
If the gain and peak have not already been adjusted, complete Steps 1 through 4 previous, then complete
the following steps.
If the skew was adjusted previously, restore the default settings before proceeding to Step 5. Adjust skew
potentiometers fully counterclockwise on R, G, and B in the following steps and save.
Tip: To adjust the volume without changing the skew settings, press the Adjust knob until the LED
turns white and then complete Step 12 in the following procedure .
To adjust the skew and volume using the RX Module Adjust Knob:
5.
Press the Adjust knob.
The LED turns red; the module is placed in Red Skew Adjust mode.
6.
Turn the Adjust knob clockwise or counterclockwise until the red color bars align as closely as
possible with the green color bars.
7.
Press the Adjust knob.
The LED turns green; the module is placed in Green Skew Adjust mode.
8.
Turn the Adjust knob clockwise or counterclockwise, if necessary, to align the green color bars with
the red color bars.
9.
Press the Adjust knob.
The LED turns blue; the module is placed in Blue Skew Adjust mode.
10.
Turn the Adjust knob clockwise or counterclockwise until the blue color bars align with the red and
green color bars.
11.
Press the Adjust knob.
The LED turns white; the module is placed in Volume Adjust mode.
FIG. 49
Test image adjusted for gain and peak (image is still skewed)
FIG. 50
Test image adjusted for skew