Temposonics
®
R-Series
V
Analog
Operation Manual
I 4 I
2.3 Installation, commissioning and operation
The position sensors must be used only in technically safe condition.
To maintain this condition and to ensure safe operation, installation,
connection and service, work may be performed only by qualified
technical personnel. If danger of injury to persons or of damage to
operating equipment is caused by sensor failure or malfunction, ad-
ditional safety measures such as plausibility checks, limit switches,
EMERGENCY STOP systems, protective devices etc. are required. In
the event of trouble, shut down the sensor and protect it against acci-
dental operation.
Safety instructions for commissioning
To maintain the sensor's operability, it is mandatory to follow
the instructions given below.
1. Protect the sensors against mechanical damage during
installation and operation.
2. Do not open or dismantle the sensors.
3. Connect the sensors very carefully and pay attention to the
polarity of connections and power supply.
4. Use only approved power supplies.
5. Ensure the sensor is operating within the defined limits for supply
voltage, environmental conditions, etc..
6. Check the function of the sensors regularly and provide
documentation of the checks.
7. Before applying power, ensure that nobody’s safety
is jeopardized by starting machines.
2.4 Safety instructions for use in explosion-hazardous areas
The sensors are not suitable for operation in explosion-hazardous
areas.
2/
See also applicable Temposonics terms of sales and delivery on:
2.5 Warranty
Temposonics grants a warranty period
2
for the position sensors and
supplied accessories relating to material defects and faults that oc-
cur despite correct use in accordance with the intended application.
The Temposonics obligation is limited to repair or replacement of any
defective part of the unit. No warranty can be provided for defects
that are due to improper use or above average stress of the product,
as well as for wear parts. Under no circumstances will Temposonics
accept liability in the event of offense against the warranty rules, no
matter if these have been assured or expected, even in case of fault or
negligence of the company.
Temposonics explicitly excludes any further warranties. Neither the
company’s representatives, agents, dealers nor employees are autho-
rized to increase or change the scope of warranty.
2.6 Return
For diagnostic purposes, the sensor can be returned to Temposonics
or a repair facility explicitly authorized by Temposonics. Any shipment
cost is the responsibility of the sender
2
. For a corresponding form,
see chapter “9. Appendix I” on page 68.
NOTICE
When returning sensors, place protective caps on male and female
connectors of the sensor. For pigtail cables, place the cable ends in
a static shielding bag for electrostatic discharge (ESD) protection.
Fill the outer packaging around the sensor completely to prevent
damage during transport.