Page 39
EVACU ELITE
INSTALLATION, COMMISSIONING AND USER MANUAL
2
Ring tone will be broadcast in the ear piece of the WIP handset.
3
The call indicator corresponding to the WIP handset that is off hook with flash at
the EICIE.
The panel buzzer at the EICIE will pulse (at the same cadence as the ring tone)
4
To establish the call, remove the handset from the cradle at the EICIE. Confidence
tone will be broadcast in the ear piece. Activate the flashing Call control.
The Call indicator goes steady.
A full duplex call between the handset at the WIP and the handset at the EICIE has
been established.
5
To terminate the call at the EICIE, place the handset at the EICIE on hook. If the
handset at the WIP remains off hook, then the EICIE treats this as a call from a
WIP handset, and the ring tone is broadcast in the ear piece of WIP handset and
the corresponding Call indicator flashes at the EICIE. Refer to section 7.5.3, step
3.
6
To terminate the call at the WIP handset, place the WIP handset into the cradle
(on hook).
The Call indicator is extinguished at the EICIE.
5.5.4 Establishing a multi-party conference call
The EICIE supports a full duplex multi-party conference call that supports up to 5 WIP handsets and the
handset at the EICIE.
A single full duplex call is established – refer to section 5.5.2 for EICIE handset to WIP handset and
section 5.5.3 for WIP handset to EICIE handset.
If another WIP handset is taken off hook, the corresponding Call indicator shall flash at the EICIE, and
by activating the Call control, the WIP is added to the call.
To call another WIP, activate the Call control associated with the WIP, the call indicator will flash until
the WIP handset is taken off hook.
To cancel a call from the WIP handset, the WIP handset is placed on hook, and the corresponding Call
indicator is extinguished.
To cancel a call to the WIP handset, the Call control is activated. If the WIP remains off hook, the Call
indicator shall flash and the ring tone is broadcast in the ear piece of the WIP handset.
5.5.5 All Call broadcast
The EICIE supports a half-duplex call to all WIP handsets.
To establish the All call, the following procedure is followed:
1
Remove the handset from the cradle at the EICIE (off hook)
2
Confidence tone will be broadcast in the ear piece, to indicate the EICIE has
recognised the handset going off hook.
