Page 29
EVACU ELITE
INSTALLATION, COMMISSIONING AND USER MANUAL
Each WIP handset in the EIS has its own controls and indicators. Refer to Figure 5-6 and 5-7 below
Figure 5-6 WIP handset with controls highlighted
There are two controls associated with each WIP
•
CALL – this control is used to establish a call to the WIP handset, and answer an incoming
call from the WIP handset. Refer to section xx for further detail.
•
ZONE CLEAR – this control is used to show that the zone associated with the WIP handset
location has been cleared of occupants – or as detailed in the site emergency management
plan. To cancel activate the control again. Control is only active when the master handset is
off hook.
Figure 5-7 WIP handset with indicators highlighted
There are three indicators associated with WIP handset
FLT
Illuminated when there is a fault associated with the WIP handset and associated
transmission path
CALL indicator – flashes red when a call is being established to a WIP handset, or
there is an incoming call from a WIP handset
ZONE CLEAR indicator – illuminates steady when the ZONE CLEAR control has
been activated.
5.1.14 Remote control indicator
If there are multiple EWCIEs networked in the EWS, the REMOTE CTRL
indicator is illuminated steady if the system is in MANUAL mode and
another EWCIE is in control.
5.1.15 Network fault indicator
The NETWORK FLT indicator is illuminated steady if there is a network
fault or a networked EWCIE is not detected
