DAVINO 120TW - USER AND MAINTENANCE MANUAL Rev.04
- Pag. 25
MACHINE PARKING
Chosse a parking zone where other vehicles do not operate.
Park the machine on a stable ground and possibly flat.
Do not park the car at the end of the day or working day in the streams or river basins.
Never park in the descent without first locking the machine to prevent accidental movement by means of
external means. For stakes in rough areas, check that there is no possibility of slipping and apply the
parking brake and blocks to the wheels.
Before turning off the engine, place the chassis in its stop position.
Always switch off the ignition key from the ignition key, leaving the machine parked in order to avoid
accidental or unauthorized start-ups.
Lock and close the machine at work, and in all cases involving temporary abandonment.
Delvier the keys to the charge. Check that all maeuvers covered in this manual have been respected.
By anticipating low temperatures, check that the cooling system is stocked with antifreeze liquid in the right
amount.
TRAIN AND RECOVERY
THE MACHINE WAS NOT DESIGNED TO TOW OTHER VEHICLES.
In the event of a tow, only for short trips, use the appropriate warnings provided by the regulations in force
and follow the instructions in this manual.
Always wear protective gloves to handle the towin elements.
DO NOT use ropes or chains for the towing.
To recover the vehicle, use only the intended attachment using appropriate tow traps.
Hook with the utmost care and make sure that the devices used are securely fastened before pulling.
Never tow a sloping machine.
Do not allow people to stay near towing vehicles.
Maintain visual contact with the operators.
Perform all the provisions in the specific chapter.
TRANSPORT
To load or unload the car from the transport vehicle, choose a flat area that offers a solid support to the
carriage or truck wheels.
Make sure that the vehicle intended for the carriage of the machine is of adequate capcity (see weights and
dimensions in setion 2.1 “technical presentation of the machine”).
The weight, the height of the carriage and the overall length of the machine vary depending on the work
equipment: check the dimensions.
Verigy that the bulkheads are permitted by the road code.
Use sturdy access ramps of height and appropriate angle.
Make sure the ramp surface is clean and free of traces of grease, oil, ice, and residues of other material.
Remore dirt from the wheels of the machine. In the event of rain, the surface of the ramps may be slippery:
pay close attention.
Make sure the truck floor is clean.
Run the engine at low speed and proceed slowly. The weight must be gradually transferred from the ramp
to the conveyor.
Never tilt the ramps to correct the position of the machine. If necessary, move away from the ramps, correct
the direction, and then go back.
The machine must be arranged so that the loads on the axles are those prescribed for the transport vehicle
and that the same is not unbalanced.
Fasten the machine securely to the floor with chains or ropes
Fasten the machine securely to the floor with chains or ropes and lock the wheels with special wedges.
Make sure the engine is off the windows and the door if is closed.
