Ametek Sorensen Asterion DC Series, Operation Manual

Page: 77 / 157

Asterion DC Series Installation
M330460-01 Rev D 2-39
CAUTION!
Connecting the power source to the computer controller through an USB hub is
not recommended. The USB connection should be direct between the two
devices.
Figure 2-21. USB Interface Connector
Connector Type
USB Interface USB series-B type Connector
Table 2-14. USB Interface Connector Type
Pin # Name Description
1 N/C No Connection
2 D- Data -
3 D+ Data +
4 GND Ground
Table 2-15. USB Interface Connector Pinout
2.14.4 LAN interface
A LAN connector (Ethernet 10BaseT/100BaseT) is located on the rear panel for
remote control; refer to Figure 2-22 for view of connector, Table 2-16 for connector
type and Table 2-17 for pin descriptions. A standard modular cable with an 8P8C
modular plug should be used between the power source and a network hub. For a
direct connection to a computer LAN card, a crossover cable with an 8P8C modular
plug is required. The MAC Address (Media Access Control) of the Ethernet port is
printed on a label on the chassis of the power source. For information on how to set up
a network connection or a direct computer connection using the LAN interface, refer to
the DC-Asterion Series Programming Manual P/N M330461-01 distributed on the CD,
M550008-01. For EMC considerations a ferrite core can be added to the cable
AMETEK P/N: 991-642-28, Manufacturer P/N: CS28B0642.