Ametek 682T-HP, User Manual

Page: 79 / 118

Chapter 6: Utility Screen, Page 72
M o d e l 6 8 2 T - H P U S E R M A N U A L A T E X Z o n e 2
To change the configured Count Time, tap the field for the desired bit pattern and enter
the new value on the pop up numeric pad. Valid Count Times are in the range of 1 to 320
seconds. Note that the Count Time will not change on the Utility screen until the Remote
signal starts analysis while the analyzer is in REMOTE operation.
The acquisition delay represents the number of seconds the first analysis will be delayed
after the “START” signal is received while the analyzer is in REMOTE operation. This
allows product some time to flow through the analyzer before the first analysis is started.
Subsequent analyses will not be affected by the acquisition delay until the analyzer is
stopped and another “START” signal is received. Configure the delay by selecting the
field and entering the number of seconds desired before the analyzer starts analysis on
receipt of the “START” signal. Change the “DISABLED” button to “ENABLED” to
enable the acquisition delay.
6.3 X-Ray Enable
You may disable the X-ray generation for troubleshooting purposes by pressing the X-
ray Enable/Disable button.
Access is allowed for Operator2 (Level 2) or higher