Chapter 4 Installation
22
Step 1 Set Switches and Jumpers,
Continued
SW1 Switch 4 Manufacturing Test
SW1 switch 4 is OFF. Do not change this switch position.
SW1 Switch 5 and Switch 6
SW1 switches 5 and 6 are not used.
SW1 Switch 8 PCI IDE Support
SW1 switch 8 must be set if a PCI IDE adapter card that requires IRQ14 is installed in PCI expansion Slot 1.
PCI Adapter Card in SLot 1
SW1 Switch 8 Setting
A PCI IDE Adapter Card is in PCI Slot 1.
ON
No PCI IDE Adapter Card is in PCI Slot 1.
OFF
J2 Parallel Port IRQ Select
J2 is a three-pin header that sets the parallel port IRQ.
Pin Settings
LPT1
Short Pins 1-2
IRQ7
(Factory setting)
Short Pins 2-3
IRQ5
J3 Select Enhanced Parallel Port DMA Request
J3 is a three-pin header that selects the parallel port DMA request line.
J3 Pin Setting
DMA Channel
Short Pins 1-2
DRQ1
Short Pins 2-3
DRQ3
(Factory setting)
Summary of Contents for Excalibur PCI
