American Magnetics 430, Installation, Operation And Maintenance Instructions

Page: 30 / 254

14 R
EV
9
A
MERICAN
M
AGNETICS
, I
NC
. I
NSTALLATION
: I
NSPECTING AND
U
NPACKING
I
NSPECTING AND
U
NPACKING
Carefully remove the equipment, interconnecting cabling, and
documentation CD (and/or printed material) from the shipping carton,
and remove all packaging material.
NOTE
If there is any shipping damage, save all packing material and
contact the shipping representative to file a damage claim. Do not
return to AMI unless prior authorization has been received.
M
ODEL
430 P
ROGRAMMER
If the Model 430 Programmer system is to be used on a table top, place
it on a flat, secure surface capable of handling the weight. The Model
430 Programmer uses an internal fan for forced-air cooling. Allow at
least 1/2 inch spacing on each side of the unit for proper ventilation.
WARNING
Do not remove the cabinet feet and then reinsert the
original screws. Doing so could present a severe, life-
threatening electrical hazard. If the cabinet feet are
removed, do not reinstall the screws. If screws must be
installed where the feet were mounted, replace the original
screws with screws not to exceed 1/4 inch in length.
If the Model 430 Programmer is to be rack mounted, install it in a 19"
wide instrument rack using the mounting hardware supplied by the rack
cabinet manufacturer. Secure the front panel to the rail in each of the
four corners.
P
OWER
R
EQUIREMENTS
WARNING
The Model 430 Programmer operates on 50/60 Hz power
and may be configured for 100-115 VAC or 200-230 VAC. The
power requirement is marked on the rear panel adjacent to
the power entry connector. Be sure the Model 430
Programmer is configured for the power source prior to
plugging in the line cord. Do not fail to connect the input
ground terminal securely to an external earth ground.