78
To designate a zone, click and drag the mouse over the area desired. When a colored box is
displayed over the live feed, that area is now enabled for motion detection.
After the motion detection zone is set, click the enter button to exit the motion
detection screen.
Remember to click the save button on the motion detection settings screen, otherwise the
motion detection zones will not go into effect. Clicking the cancel button to leave the motion
detection zone and will not save the zone setup.
•
Enable Manual Control Trigger:
This checkbox allows the user to enable manual PTZ control triggered
events.
•
Record
: This checkbox allows the user to enable the camera to record video when a motion detection
alarm is triggered.
•
Record Delay
: This field specifies in seconds how long the delay between alarm activation and
recording should be.
•
Relay Out
: This checkbox allows the user to enable the camera to trigger a connected alarm
(connected to the alarm port on the back of the camera) when a motion detection alarm is triggered.
•
Alarm Delay
: This field specifies in seconds how long the delay between alarm activation and Relay
alarm activation should be.
•
Send Email
: This checkbox allows the user to enable the camera to send an email when a motion
detection alarm is triggered.
•
PTZ:
This checkbox allows the user to enable PTZ events to be sent from the camera. This event can
be sent via email alerts or via the web interface directly.
•
Snapshot
: This checkbox allows the user to enable the camera to take a snapshot when a motion
detection alarm is triggered.
To reset to default settings, click the Reset Defaults button. To refresh the page, click the Refresh button. To
save the settings, click the Save button.
5.8.1.2 Video Tampering
This tab allows the user to modify video tamper settings. Below is a screenshot of the
Video Tamper tab: