12
Note:
For a more detailed representation of the process, please
refer to figure
3.4.2
below:
Figure 3.4.2
3.4.3 Cement Installation
1. Using a 3/16 Allen wrench, remove the three security screws from the
mounting bracket to remove the unit from its base.
2. Using the mounting bracket, mark holes in the appropriate areas you
would like to mount the camera.
3.
Remove the mounting bracket and using a 1” drill bit, drill a hole into
the center of the surface area.
4. Run the camera wiring through the mounting bracket and to the
applied 1” hole created for in
-wall installation.
5. Using a 9/16 drill bit, drill a hole into each marked area to insert the
appropriate concrete anchor screw into the hole.
6. Align the mounting bracket to the drilled holes and place the 9/16
concrete anchor screw to the mounting bracket.
7. Using an impact or manual wrench, drive the concrete anchors into the
appropriate hole to secure the bracket to the surface area.
8. Secure the camera back to the mounting bracket with the three
provided bolts using a 3/16 Allen wrench.
Note:
For a more detailed representation of the process, please refer to
figure
3.4.3
below:
Figure 3.4.3