EN
17
Fixture
Mounting interface
75mm (2.96”)
Fits poles with thicknesses
10mm ~ 45mm (0.4 ~ 1.8”)
aView power supply
Weight
360g (0.79 lbs)
Electrical power
Power requirement
100 - 240V AC; 50-60Hz; 0.6A
Power out
18V DC; 1.67A
Operating environment
Temperature
10 ~ 40° C (50 ~ 104° F)
Storage
Temperature
10 ~ 40°C (50 ~ 104°F)
Relative humidity
10 ~ 90%
Plugs
Between the power supply and aView
Ø5.5mm DC jack connector
5 interchangeable types
1) Model NEMA 5 AC grounded power plug
2) Australian configuration: AS3112, AC grounded power plug
3) UK configuration: BS1363, AC grounded power plug
4) European configuration: CEE 7, AC grounded power plug
5) Danish configuration: 2-5a, AC grounded power plug
6. Connecting accessories
CAUTION
The aScope 3 system consists of the parts described in section 2. They may only be replaced by Ambu authorized parts. Failure to comply with this may
reduce safety and efficiency.
The aView is not intended to be repaired. If defect the aView shall be discarded.
aView can be placed on a solid flat surface by using the stand on the back of aView. If needed, aView can be placed by using the supplied bracket.
6.1. Charging aView
Connect the aView power supply to the wall socket and insert the power plug into the power inlet of the aView.
If the aView is turned on during charging the ON/OFF button will light orange. The battery icon will change as shown here:
Max. battery status
of the aView
Min. battery status
of the aView
The icon remains white until one block is left, after which it turns red.
When remaining battery capacity is 10% the red battery icon starts flashing
Charging is shown with blocks flashing
Current capacity is shown with non-flashing blocks
Battery is charging
Battery current
capacity
If the battery is fully charged and still connected to a charger the battery icon changes to:
6.2 Maintenance of battery
To prolong battery life it is recommended to fully charge the monitor at least every third month and store it in a cool place. If the battery is flat the
procedure takes approximately 3-4 hours. The battery should be charged at temperatures between 10 - 40°C.
