Amazone UF 1201, Operating Manual

Page: 29 / 220

General safety instructions
Machine transportation
•
Comply with the national road traffic regulations when using
public highways.
•
Before moving off, check:
ο
the correct connection of the supply lines
ο
the lighting system for damage, function and cleanliness
ο
the brake and hydraulic system for visible damage
ο
that the parking brake is completely disengaged
ο
the function of the brake system
•
Ensure that the tractor has sufficient steering and braking power.
Any machines and front/rear weights connected to the tractor
influence the driving behaviour and the steering and braking
power of the tractor.
•
If necessary, use front weights.
The front tractor axle must always be loaded with at least 20% of
the tractor empty weight, in order to ensure sufficient steering
power.
•
Always fix the front or rear weights to the intended fixing points
according to regulations.
•
Comply with the maximum load for the connected machine and
the approved axle and drawbar loads for the tractor.
•
The tractor must guarantee the prescribed brake delay for the
loaded vehicle combination (tractor plus connected machine).
•
Check the brake power before moving off.
•
When turning corners with the machine connected, take the
broad load and balance weight of the machine into account.
•
If the machine is fixed to the tractor's three-point linkage or lower
links, before moving off, ensure sufficient side locking of the trac-
tor lower links.
•
Before moving off, move all the swivellable machine parts to the
transport position.
•
Before moving off, secure all swivellable machine parts in the
transport position against dangerous position changes. Use the
transport safety catches intended for this.
•
Before moving off, secure the operating lever of the three-point
hydraulic system against the unintentional raising or lowering of
the connected machine.
•
Check that the transport equipment, e.g. lighting, warning
equipment and protective equipment, is correctly mounted on the
machine.
•
Carry out a visual check that the upper and lower link pins are
firmly fixed with the linchpin against unintentional release.
•
Adjust your driving speed to the prevailing conditions.
•
Before driving downhill, switch to a low gear.
•
Before moving off, always switch off independent wheel braking
(lock the pedals).
UF BAG0012.11 04.19 29